Abstract
Objectives: The aim of this study was to assess the shear bond strength (SBS) of zirconia ceramic to composite resin with various surface treatments following pressure changes. Materials and Methods: Totally, 135 zirconia blocks were prepared by computer-aided design/computer-aided manufacturing technology. The samples were divided into 9 groups (n=15). Three surface treatments including sandblasting, tribo-chemical preparation, and laser application were used. For each method, 45 samples were considered and tested under different pressure conditions. Z-Prime Plus primer was used for bonding of all samples to composite cylinders. All specimens were stored in water for 24 h, underwent thermocycling, and were then placed in a pressure chamber under normal-, high-, and low-pressure conditions. Then, the SBS test was performed for each sample. Data were analyzed by two-way and one-way ANOVA (α=0.05). Results: The SBS was significantly higher in sandblasting and tribochemical preparation compared with laser irradiation (P<0.05). There was no statistically significant difference in SBS of sandblasting and tribochemical preparation methods (P>0.05). Sandblasting, tribochemical preparation, and laser methods did not show a significant difference in SBS at different pressures (P>0.05). Conclusion: Sandblasting and tribochemical preparation yielded a higher SBS than laser. Different pressures had no effect on SBS, irrespective of surface preparation method.