Abstract
Fiber structures with connected pores resemble the natural extracellular matrix (ECM) in tissues, and show high potential for promoting the formation of natural functional tissue. The geometry of composite fibers produced by electrospinning is similar to that of the living-tissue ECM, in terms of structural complexity. The introduction of liquid crystals does not affect the morphology of fibers. The composite mat shows better hydrophilicity, with higher content of liquid crystal. At the same time, the higher the content of liquid crystal, the lower the modulus and tensile strength, and the higher the breaking energy and the elongation at break. Additionally, the factors affecting fibers are also investigated in this study. The addition of liquid crystals to the fibers' matrix can slow down the release of pDNA, which is the most common vehicle for genetic engineering, and the encapsulation of pDNA polymer into the fiber matrix can maintain biological activity. The continued release of the pDNA complex was achieved in this study through liquid crystals, and the effective release is controllable. In addition, the integration of liquid crystals into fibers with pDNA polymers can cause a faster transfection rate and promote HUVEC (Human Umbilical Vein Endothelial Cells) growth. It is possible to combine electrospun fibers containing LC (liquid crystal) with pDNA condensation technology to achieve the goal of a sustained release. The production of inductable tissue-building equipment can manipulate the required signals at an effective level in the local tissue microenvironment.