Abstract
The paper analyzes the suitability of four types of biomass pellets as a fuel for heating purposes. Three types of waste biomass (sunflower husks, rapeseed cake, and corn straw) and one type of biomass grown for energy purposes (willow) were selected. After appropriate preparation, the selected starting materials were subjected to the pelletization process. Selected physical and chemical properties of the studied biomass pellets were determined. All four types of the analyzed pellets met the EN-ISO-17225-2:2014 standard in terms of bulk density, dimensions, as well as nitrogen and moisture content. The highest calorific value was pellets made of sunflower husk (17.27 MJ/m3) and willow (16.81 MJ/m3), while the calorific value of pellets made of corn straw and rapeseed cake did not exceed 16.5 MJ/m3 and did not meet the standard. In addition, the ash content for these two types of pellets was well above the standard. A 10 kW domestic biomass boiler was employed for burning the tested pellets. The consumption of analyzed fuels during boiler operation was determined. The concentration of CO, CO2, and NOx in exhaust gases was also examined. The obtained experimental results were compared with the numerical calculations with the use of ANSYS Chemkin-Pro using two mechanisms. The highest concentrations of CO2 and CO were observed during the combustion of sunflower and willow husk pellets, which probably resulted from the highest carbon content and, thus, the highest calorific value when compared to cake and straw pellets. For all analyzed pellets, the value of NO and NO2 concentration was similar and did not exceed 368 ppm and 18 ppm, respectively. The results closest to the experiment were obtained for calculations using the mechanism developed by Glarborg et al. The research carried out in the article shows that out of the four analyzed types of pellets, only sunflower and willow husk pellets can be burned in a domestic boiler adapted to burning wood pellets, which is a cheap alternative to wood pellets.