Abstract
Thermally induced phase separation (TIPS) is a technique to prepare commercial membrane. However, the quick polymer crystallization during the quenching process will bring about a dense and thick skin layer and thus decrease permeability markedly. In this paper, a diluent mixture with upper critical solution temperature (UCST) was used to prepare polyvinylidene fluoride (PVDF) hollow fiber membrane. That is, the separation between diluent (propylene carbonate (PC)) and non-diluent (dioctyl terephthalate (DOTP)) occurred during the quenching process when the temperature of the dope was lower than 110 °C. The effects of separation between PC and DOTP and the resulting coalescence of DOTP on the PVDF crystallization process, microstructure, and the permeability of the membranes were analyzed. The results showed that the suitable PC/DOTP weight ratio reduced the thickness of the skin layer near the outer surface markedly and resulted in a porous outer surface, and the microstructure evolution process was proposed. The maximum pure water flux for the prepared membrane is up to 128.5 L·m(-2)·h(-1) even in a dry mode without using a hydrophilizing agent. The rejection rate of the carbonic particle is nearly 100%. This study presents a novel and simple way to fabricate the microporous membrane with the interconnected pore structure.