Abstract
BACKGROUND: Despite the advancement of 3-dimensional (3D) printing technology with medical application, its neurosurgical utility value has been limited to understanding the anatomy of bones, lesions, and their surroundings in the neurosurgical field. OBJECTIVE: To develop a 3D printed model simulating the surgical technique applied in skull base surgery (SBS), especially to reproduce visually the surgical field together with the mechanical properties of tissues as perceived by the surgeon through procedures performance on a model. METHODS: The Young modulus representing the degree of stiffness was measured for the tissues of anesthetized animals and printing materials. The stiffness and vividness of models were adjusted appropriately for each structure. Empty spaces were produced inside the models of brains, venous sinuses, and tumors. The 3D printed models were created in 7 cases of SBS planned patients and were used for surgical simulation. RESULTS: The Young modulus of pig's brain ranged from 5.56 to 11.01 kPa and goat's brain from 4.51 to 13.69 kPa, and the dura of pig and goat values were 14.00 and 24.62 kPa, respectively. Although the softest printing material had about 20 times of Young modulus compared with animal brain, the hollow structure of brain model gave a soft sensation resembling the real organ and was helpful for bridging the gap between Young moduli values. A dura/tentorium-containing model was practical to simulate the real maneuverability at surgery. CONCLUSION: The stiffness/vividness modulated 3D printed model provides an advanced realistic environment for training and simulation of a wide range of SBS procedures.