Unraveling Plasmon-Enhanced Reactive Oxygen Species Generation through Ultrafast Light.

利用超快光揭示等离子体增强活性氧的产生机制

阅读:6
作者:Rajagopal Ramprasath, Kundu Koustav, Ouyang Tianhong, Nalluri Akilesh, Liu Gwen, Ziegler Lawrence D, Erramilli Shyamsunder, Reinhard Björn M
Reactive oxygen species (ROS) generation through gold nanorods (AuNRs) excited by 812 nm centered, 85 femtosecond (fs)-pulsed laser irradiation was investigated through a rhodamine B degradation assay. The initial rate of rhodamine B fluorescence intensity degradation is determined by the rate of ROS generation, but at later time points the laser irradiation induced deformation of AuNRs reduces the rate of rhodamine B degradation. For different AuNR preparations that all had a localized surface plasmon resonance (LSPR) mode at around 800 nm but differed in size, the initial rate of rhodamine B fluorescence intensity decrease follows a trend predicted by the simulated peak near-field intensities and absorption efficiencies except for the smallest AuNRs with dimensions of 30 by 7 nm. The initial rate of ROS generation exhibits a power law dependence on the fluence. The reshaping of the AuNRs on longer timescales also depends on the fluence. For 2.3 mJ/cm(2) the establishment of a stable regime is observed, where an initial reshaping of the AuNRs decreases the spectral overlap between longitudinal plasmon resonance and excitation wavelength so that the absorbed energy is insufficient to induce further structural changes but still allows for ROS generation. For a fluence of 3.9 mJ/cm(2) the AuNR plasmon spectrum almost completely detunes from the excitation wavelength, resulting in a further reduction of ROS generation. AuNR reshaping and ROS generation also depend on the surface passivation of the AuNRs. Intriguingly, a lipid-coating was observed to provide a relative stabilization of the AuNRs when compared with polyethyleneglycol (PEG) or cetyltrimethylammonium (CTAB) surface chemistries and still allow for ROS generation.

特别声明

1、本文转载旨在传播信息,不代表本网站观点,亦不对其内容的真实性承担责任。

2、其他媒体、网站或个人若从本网站转载使用,必须保留本网站注明的“来源”,并自行承担包括版权在内的相关法律责任。

3、如作者不希望本文被转载,或需洽谈转载稿费等事宜,请及时与本网站联系。

4、此外,如需投稿,也可通过邮箱info@biocloudy.com与我们取得联系。