Abstract
Geotechnical centrifuges are valuable instruments for physical modelling of complex geotechnical problems in a controlled laboratory setting. In comparison to full-scale testing, scaled models are cost effective to construct and instrument and, when tested in a geotechnical centrifuge at increased centrifugal accelerations, are capable of replicating full-scale stress-strain soil behaviour. Centrifuge modellers require specialised hardware and instruments capable of functioning under high accelerations. Such hardware is costly, nearly always purpose built, and often rely on commercial, closed-source data acquisition systems, hardware and control systems. This paper demonstrates a novel and versatile, low cost, open source logger and control system that works in parallel alongside existing centrifuge hardware. This solution, termed Fly-by-Pi, was developed using the Raspberry Pi microcomputer. The system provides closed-loop control of linear actuators with the ability to operate in either cyclic, monotonic, or static load- or displacement-control. The control mechanism can be reprogrammed according to experimental requirements, even during flight in the centrifuge. Three independent experiments are described which included the Fly-by-Pi controller as a key component in their operation. Based on the experience gained during these experiments, the authors encourage wide-spread adoption of open-sourced hardware solutions in extreme testing environments.