Abstract
PURPOSE: This study aimed to evaluate the efficiency of a digital workflow by comparing the accuracy of prosthetic teeth positioning between virtual standard-size digitally constructed and conventional dental laboratory-fabricated prostheses. METHODS: Twenty-five computed tomography datasets with a dentate upper jaw were selected after applying inclusion criteria to 100 random datasets obtained from the institutional library, and partially edentulous maxillae were constructed virtually. Digital datasets of temporary prostheses were fabricated on these virtually constructed edentulous maxillae in two ways: one dataset comprised prostheses that were fabricated conventionally using prosthetic teeth and wax in the dental laboratory and then scanned using a model scanner, whereas the other dataset was designed virtually using standardized virtual dental arches. The digital datasets of both prostheses were compared for differences at six dental-based measurement points with the original patient dentition. RESULTS: Overall, the conventional design pathway was more accurate than the digital one (conventional 2.915 ± 1.388 mm, digital 3.609 ± 2.052 mm, P < 0.001). However, when all six measurement points were evaluated individually, only three points showed significant differences in the tooth positions. Compared with the original dentition, the deviations were less in the anterior teeth region than in the molar region, fulfilling the esthetic expectations of the patients. Standardized virtual dental arches were practically adequate because virtual reconstruction of every edentulous case using these virtual arches was possible without any additional modifications. CONCLUSION: It is possible to fabricate clinically acceptable temporary prostheses using a comprehensive digital workflow based on standardized digital dental arches.