Abstract
AIM: To simulate in a laboratory setting longitudinal cracking in root filled premolar teeth, using cyclic mechanical fatigue. METHODOLOGY: Mesial-occlusal-distal (MOD) cavities were prepared in twenty root filled, single-rooted, mandibular premolars restored with fibre posts and resin composites. The samples were randomly divided into two groups based on the loading approaches: static loading with a crosshead speed of 0.5 mm/min and step-stress cyclic loading (1 Hz) with increasing amplitude. The loads and numbers of cycles to failure were recorded. Micro-CT was also used to identify the fracture modes. Statistical analysis was performed using Student's t-test. The level of significance was set at 0.05. RESULTS: The mean fracture loads for the static loading and cyclic loading groups were 769 ± 171 N and 720 ± 92 N, respectively. There was no significant difference between the two groups (P > 0.05). The proportions of longitudinal, cuspal and mixed-mode fractures under cyclic loading were 50%, 20% and 30%, respectively. Longitudinal fractures occurred with larger numbers of cycles and higher average loads per cycle compared with the other fractures. Static loading produced only cuspal fractures. CONCLUSIONS: Longitudinally cracked premolar teeth with root fillings were successfully produced using the step-stress cyclic loading method. This provides a more clinically representative methodology for studying cracked teeth in a laboratory setting.