Abstract
BACKGROUND/PURPOSE: It is not clear whether the ground surface of resin-based composite (RBC) polymerized requires the application of an adhesive with/without a silane to improve bond strength. This study investigated the bond strength of RBC repaired within 24 h via the application of adhesive with/without a silane. MATERIALS AND METHODS: Seventy RBC blocks were prepared and assigned to either 0 or 24 h repair stage. Each stage was divided into seven groups: a control group with no surface roughening or applied adhesive, a surface-roughened group with no applied adhesive, two surface-roughened groups treated with a G-aenial Bond adhesive and a BeautiBond Multi adhesive, two surface-roughened groups treated with the previously-mentioned adhesives as well as silane coupling agents, and one group treated with a Single Bond Universal silane-containing adhesive. Microtensile bond strength (μTBS) measurements were performed after the repaired RBC blocks of each group (n = 5) had been immersed in a 37 °C water bath for 24 h. The failure mode of each sample was determined, and the data were analyzed via one-way analysis of variance and Dunnett's test (p = 0.05). RESULTS: Regardless of the repair stage, the μTBS values of the adhesive-only and silane-adhesive groups did not differ significantly from those of the control group (p > 0.05). Only the no-adhesive groups exhibited a significantly time-dependent increase in adhesive failure rate. CONCLUSION: Our results suggest that the application of adhesives either with or without silane can significantly increase the bond strength of repairs to RBCs polymerized within 24 h.