Abstract
We have performed molecular dynamics simulations of protein surface loops solvated by explicit water, where a prime focus of the study is the small numbers (e.g., ~100) of explicit water molecules employed. The models include only part of the protein (typically 500 - 1000 atoms), and the water molecules are restricted to a region surrounding the loop. In this study, the number of water molecules (N(w)) is systematically varied, and convergence with large N(w) is monitored to reveal N(w)(min), the minimum number required for the loop to exhibit realistic (fully hydrated) behavior. We have also studied protein surface coverage, as well as diffusion and residence times for water molecules as a function of N(w). A number of other modeling parameters are also tested. These include the number of environmental protein atoms explicitly considered in the model, as well as two ways to constrain the water molecules to the vicinity of the loop (where we find one of these methods to perform better when N(w) is small). The results (for RMSD and its fluctuations for four loops) are further compared to much larger, fully solvated systems (using ~10,000 water molecules under periodic boundary conditions and Ewald electrostatics), and to results for the GBSA implicit solvation model. We find that the loop backbone can stabilize with a surprisingly small number of water molecules (as low as 5 molecules per amino acid residue). The side chains of the loop require somewhat larger N(w), where the atomic fluctuations become too small if N(w) is further reduced. Thus, in general, we find adequate hydration to occur at roughly 12 water molecules per residue. This is an important result, because at this hydration level, computational times are comparable to those required for GBSA. Therefore these "minimalist explicit models" can provide a viable and potentially more accurate alternative. The importance of protein loop modeling is discussed in the context of these, and other, loop models, along with other challenges including the relevance of appropriate free energy simulation methodology for assessment of conformational stability.