Abstract
PURPOSE: The aim of this study was to establish guidelines for the selection of cast and wrought-wire clasps for removable partial dentures (RPDs) that would be appropriate for clinically encountered undercuts and facial curvatures. METHODS: Randomly selected discarded casts were collected and 30 premolars and 30 molars were surveyed, sectioned to a line representing the clasp and scanned using a flatbed scanner. The average clasp curvature and length for each group was determined and a three-dimensional model printed, to which wrought wire clasps of 0.9- and 1.0-mm diameter were adapted. Standard wax clasp patterns were adapted and cast in a stellite alloy. Each clasp was deformed beyond its proportional limit; and the forces exerted at that limit and at deflections of 0.25 mm, 0.5 mm, and 0.75 mm were measured, and a safety limit was calculated that would ensure elastic deformation at the required undercuts. RESULTS: A table was produced with guidelines for those clasps that would provide the highest retentive force within the proposed safety limit. The highest forces were provided by cast clasps in a 0.25-mm undercut. Wrought round wire of 1-mm diameter provided the next highest retentive forces, in a 0.25-mm undercut for premolar clasps arms and 0.5-mm for molar clasps. CONCLUSIONS: The results provide valid guidelines for the use of combinations of clasp material and undercut that would exert the maximum retentive force without deformation for both short (premolar) as well as long (molar) clasps, for wrought and cast clasps.