Abstract
PURPOSE: The aim was to prove the possibility of creating an exact module of knee cartilage defects using 3D printing. METHODS: Defects were created in cadaver knees. CT-arthrography and 3-Tesla MRI were performed. Based on CTA images a model of the cartilage was created using 3D printing. Defect-sizes in the imaging modalities were compared. RESULTS: Estimated lesion area in 3D model differed approximately 5% comparing to the defect sizes in knees. MRI underestimated the defect on average of 12%, whereas the CTA overestimated the defect about 3%. CONCLUSIONS: We proved the feasibility of creating an accurate module of knee cartilage.