Abstract
Colombia is one of the world's leading exporters of coal and coke, with significant reserves of high-quality coal. Most of the coal exported from Colombia is used for power generation, but there is also a class of coal that is suitable for making coke. Coke is a raw material required for making steel, and it is produced by heating coal to high temperatures in the absence of air. Colombia is the third-largest global exporter of coke, with a significant portion of its exports going to the steel industry in countries such as Brazil, Mexico, and the United States. The country's high-quality coal reserves and proximity to major markets make it an important player in the global coal and coke trade. On the other hand, graphene and its derivative Graphene Oxide (GO) have unique properties that make them suitable for a wide range of commercial applications. Graphene has exceptional mechanical strength and high electrical conductivity, which make it an attractive material for a variety of electronic and structural applications. For example, graphene-based materials are being developed for use in flexible electronic devices, sensors, and high-strength composites. GO, on the other hand, is highly resistive but still retains exceptional mechanical strength. This makes it useful in applications where electrical conductivity is not necessary but mechanical strength and durability are important. Graphene production using current techniques can be expensive and inefficient, which limits its widespread adoption for commercial applications. However, new production methods, such as Liquid Phase Exfoliation (LPE), are being developed to address these challenges. LPE is a method for producing graphene and graphene oxide that involves using a liquid solvent to break apart graphite into individual graphene sheets. This method is more efficient and cost-effective than traditional methods such as mechanical exfoliation and chemical vapor deposition. In recent years, there has been increasing interest in using high-rank coal from Colombia as a raw material for graphene production using LPE. This is because high-rank coal from Colombia is known to have a high carbon content and low impurity levels, which makes it an ideal raw material for graphene production. Researchers have successfully produced GO using the LPE method and high-rank coal from Boavita, Colombia. This has the potential to significantly increase the supply of graphene and graphene oxide, making it more accessible for commercial applications. Additionally, using coal as a raw material for graphene production has the potential to create a new market for coal, which could benefit the Colombian economy. In order to synthesize GO, it is important to establish a suitable protocol for the grinding procedure and particle size selection. (i. more than 0.15 mm, ii. 0.15 mm to 0.05 mm, and iii. less than 0.05 mm) were defined. To compare the yield, the mineral matter removal procedure was carried out with a basic leaching bath. Coal oxidation was performed using the modified Hummers process, and GO was then obtained using LPE. This method has the following advantages:•It is feasible to produce GO from high-rank coal with acceptable quality and particulate size smaller than 0.15 mm, yields that are close to 5%, and flakes with fewer than 15 layers.•This approach also could eliminate dependence on graphite as the carbon feedstock for graphene production.•It is an alternative to manufacture GO from coal dust collected from mines.