Abstract
The yellowing effect of camphorquinone (CQ) has led manufacturers to add alternative initiators into resin composites (RCs) to reduce the amount of CQ used. The aim of this study was to investigate the color change in commercial RCs with alternative photoinitiators besides CQ. Color change upon polymerization and aging in air and artificial saliva for up to 3 months was tested for seven commercial RCs (traditional and bulk-fill) with either CQ only or CQ and additional photoinitiators (CQ+). Color measurements were obtained with a spectrophotometer. Color change (ΔE) was calculated using the CIELab and CIEDE2000 formulae. ANOVA and a post hoc SNK test were conducted for statistical analysis. Upon polymerization, the ΔE of CQ+ was greater than that of CQ only, except in the case of dual-cure HyperFIL. The storage conditions did not affect the color change within 24 h for either air or artificial saliva, whereas they did have an influence on color stability when RCs were aged for 1 month and 3 months. The color changes in the RCs aged in artificial saliva were considered clinically acceptable for all RCs tested except HyperFIL. Additional photoinitiator systems tended to result in a greater color change upon polymerization but did not affect color change upon aging. During shade selection, especially when additional photoinitiators besides CQ are used, a guide reflecting the color after polymerization should be used.