Abstract
In order to find new ways to ensure sustainable development on a global level, it is essential to combine current top technologies, such as additive manufacturing, with the economic, ecological, and social fields. One objective of this paper refers to wire manufacture such as Arboblend V2 Nature, Arbofill Fichte, and Arboblend V2 Nature reinforced with Extrudr BDP "Pearl" (BDP-Biodegradable Plastic) in order to replace the plastic materials. After wire manufacture by extrusion, the diameter accuracy was analyzed compared with the Fiber Wood wire using SEM analyses and also EDAX-Energy Dispersive X-ray Analysis and DSC-Differential Scanning Calorimetry analyses were done in order to identify their elemental composition and the phase transitions suffered by the materials during heating. Using the samples obtained through the Fused Deposition Modeling (FDM) method, both crystalline phases and chemical composition information (XRD analysis) were identified, as well was determined the visco-elastic behavior Dynamic Mechanical Analysis (DMA), for the reinforced material and Fiber Wood. The extruded wires have allowed size for the printing equipment, around 1.75 mm with tolerance of ± 0.05 mm. The wire material diagrams, Arboblend V2 Nature reinforced with Extrudr BDP "Pearl" and Fiber Wood following the calorimetric analysis, presented peaks corresponding to material crystallization, while Arbofill Fichte revealed only the melting temperature. The storage module was almost double in case of Arboblend V2 Nature reinforced with Extrudr BDP "Pearl" compared with Fiber Wood and materials' melting temperatures were confirmed by the analyses carried out.