Abstract
Whether used as structural components in design or matrix materials for composites, the mechanical properties of polymers are increasingly important. The compressive response of extruded polymethyl methacrylate (PMMA) rod with aligned polymer chains and Al-Ni-PMMA particulate composites are investigated across a range of strain rates and temperatures. The particulate composites were prepared using an injection-moulding technique resulting in highly anisotropic microstructures. The mechanics of these materials are discussed in the light of theories of deformation for glassy polymers. The experimental data from this study are compared with PMMA results from the literature as well as epoxy-based composites with identical particulates. The PMMA exhibited the expected strain rate and temperature dependence and brittle failure was observed at the highest strain rates and lowest temperatures. The Al-Ni-PMMA composites were found to have similar stress-strain response to the PMMA with reduced strain softening after yield. Increasing volume fraction of particulates in the composite resulted in decreased strength.