Abstract
The article presents the results of original research on determining the abrasive properties of composite materials with an epoxy resin matrix reinforced with basalt particles in the form of powder and pine chips from the post-production waste of wooden elements. There are many studies available in the literature on the modification of composite materials in terms of achieving the required strength properties, but there is little information available in the area of achieving specific functional properties of composite materials, e.g., abrasive properties. Three composite materials with different proportions of the material components were made. These materials were tested using standardized tests to determine their mechanical properties, and these properties were compared in relation to the matrix material (epoxy resin). In order to determine the abrasive properties, an original research stand was made, on which the composites were tested using counter-samples made of an aluminum alloy. The mass loss of samples and counter-samples after the friction test was measured and determined. Changes in the electrospindle supply current and rotational measurements were also made. The values measured and determined in the tests were used as indicators of the abrasiveness of composite materials. It was shown that both the loss of mass of the sample and counter-sample and the parameters of the electrospindle operation are good, convenient indicators of the abrasive properties of the tested materials. The obtained results were subjected to statistical analyses. Optical 3D scans of the surfaces of exemplary samples were presented.