Abstract
This study investigates the incorporation of algae-based activated carbon into polyurethane foam to improve a biocomposite for gasoil sorption. The biocomposites were thoroughly analyzed using various techniques to examine the properties of both the blank foam and the algae activated carbon foam with a carbon content of 4.41 mass% and particle diameter of 500 µm. These techniques included Scanning Electron Microscopy (SEM), thermogravimetric analysis (TGA), and density analysis. The TGA analysis revealed that the biocomposites had an impact on the onset temperature (T(onset)) of the foams. Higher concentrations of the biocomposites resulted in a decrease in T(onset) from approximately 310 °C in the blank foam (PUF0) to 300 °C in the composite (PUF3B). The final residue percentage also decreased from around 20% in PUF0 to 10% in PUF3B. Density analysis showed that the apparent density of the foam increased from 0.016 g/cm(3) in the blank foam to 0.020 g/cm(3) in the biocomposite (PUF3B), while the real density slightly decreased from 0.092 g/cm(3) to 0.076 g/cm(3), indicating a reduction in overall porosity from 82.5% to 74.4%. All foams that were modified showed an increase in their ability to absorb gasoil in a PUF/gasoil/water system. The optimized biocomposite (PUF1B), with 1.14 mass% of 500 µm algae carbon, displayed the highest sorption capacity, starting at approximately 50 g/g at 1.5 h and increasing to 53 g/g over 72 h. The analysis of adsorption kinetics revealed that by utilizing adsorption isotherms, particularly the Langmuir isotherm, a more accurate fit to the data was achieved. This allowed for the prediction of the maximum gasoil adsorption capacity. This study aims to further develop, analyze, and utilize biocomposites made from algae-based activated carbon and polyurethane. These materials offer a sustainable and environmentally friendly approach to cleaning up oil spills.