Abstract
Availability of 3D-printed laboratory equipment holds promise to improve arthropod digitization efforts. A 3D-printed specimen scanning box was designed to image fluid-based arthropod collections using a consumer-grade flatbed scanner. The design was customized to accommodate double-width microscope slides and printed in both Polylactic Acid (PLA) and nylon (Polyamide). The workflow with two or three technicians imaged Trichoptera lots in batches of six scanning boxes. Individual images were cropped from batch imagess using an R script. PLA and nylon both performed similarly with no noticeable breakdown of the plastic; however, dyed nylon leeched color into the ethanol. The total time for handling, imaging, and cropping was ~8 minutes per vial, including returning material to vials and replacing ethanol. Image quality at 2400 dpi was the best and revealed several diagnostic structures valuable for partial identifications with higher utility if structures of the genitalia were captured; however, lower resolution scans may be adequate for natural history collection imaging. Image quality from this technique is similar to other natural history museum imaging techniques; yet, the scanning approach may have wider applications to morphometrics because of lack of distortion. The approach can also be applied to image vouchering for biomonitoring and other ecological studies.