Abstract
This study focuses on using activated fly ash to preparate silica aerogel by the acid solution-alkali leaching method and ambient pressure drying. Additionally, to improve the performance of silica aerogel, C(6)H(16)O(3)Si (KH-570) and CH(3)Si(CH(3)O)(3) (MTMS) modifiers were used. Finally, this paper investigated the factors affecting the desilication rate of fly ash and analyzed the structure and performance of silica aerogel. The experimental results show that: (1) The factors affecting the desilication rate are ranked as follows: hydrochloric acid concentration > solid-liquid ratio > reaction temperature > reaction time. (2) KH-570 showed the best performance, and when the volume ratio of the silica solution to it was 10:1, the density of silica aerogel reached a minimum of 183 mg/cm(3). (3) The optimal process conditions are a hydrochloric acid concentration of 20 wt%, a solid-liquid ratio of 1:4, a reaction time of two hours, and a reaction temperature of 100 °C. (4) The optimal performance parameters of silica aerogel were the thermal conductivity, specific surface area, pore volume, average pore size, and contact angle values, with 0.0421 W·(m·K)(-1), 487.9 m(2)·g(-1), 1.107 cm(3)·g(-1), 9.075 nm, and 123°, respectively. This study not only achieves the high-value utilization of fly ash, but also facilitates the effective recovery and utilization of industrial waste.