Abstract
This article presents the results of research on the effect of plasticisers made based on four different compounds-melamine (M), naphthalene (NF), acrylic polymers (AP) and polycarboxylic ethers (PC)-added to the tested mixes in the amount of 2% of the fly ash (FA). The influence of superplasticisers (SPs) on the consistency of the fresh concrete was investigated using a flow table and a penetrometer, and the air voids content was determined by means of a porosimeter. Additionally, the influence of plasticisers on the viscosity of the paste was investigated using a rheometer. Hardened mortar that matured under two different conditions was also tested at elevated and room temperatures. The tested properties were 7-, 28- and 90-days compressive strength and internal microstructure viewed under a microscope. NF had the greatest viscosity-reducing effect while it increased the air void volume in the mix at the same time. The highest early and late strengths were obtained after curing in elevated temperature samples with an acrylic-polymer-based superplasticiser. However, the increased curing temperature of the samples only influenced the early strength results. Its effect was not visible after 90 days. The AP addition also had a significant impact on improving the consistency of the mixture. The addition of plasticisers did not affect the microstructure of the specimens.