Abstract
Accurate dosimetry is crucial for the ongoing development and clinical study of photodynamic therapy (PDT). Current dosimetry standards range from less accurate methods involving measurement of only light fluence and photosensitizer concentration during treatment, to significantly improved methods such as singlet oxygen explicit dosimetry (SOED), a macroscopic model that includes an additional important parameter in its dosimetric calculations: ground-state oxygen concentration ([(3)O(2)]). However, neither of these models is a method of direct dosimetry. Multispectral singlet oxygen luminescence dosimetry (MSOLD) shows promise in this regard but requires significant improvement in signal quality and remains to be validated in a clinical setting. In this study, we validate a linearly increasing MSOLD signal with an InGaAs photodiode detector for increasing concentration (0 mg/kg to 200 mg/kg) in tissue-simulating phantoms containing photofrin, calculating a calibration curve based on 1270 nm peak-intensity signal and area under the curve for background-subtracted singlet oxygen emission. Additionally, we validate MSOLD against the current clinical dosimetry standard, SOED, through simultaneous measurement of SOED parameters and MSOLD signal for varying concentrations (50 μM - 300 μM). Finally, we investigate the effects of using very high gain amplification on InGaAs photodiode detectors to amplify the MSOLD signal for use in clinical models. We show that a calibration curve relating photosensitizer concentration (PS) and MSOLD signal can be established. Additionally, we demonstrate good correlation between MSOLD signal and SOED-calculated [(1)O(2)](rx). However, we show that when using high amplification on InGaAs photodiodes for long illumination times, the inherent instability in these detectors becomes apparent.