Abstract
BACKGROUND: Different techniques and materials such as bone grafts and bioactive agents have been used for alveolar ridge augmentation in extraction sockets with a defective wall, there is not a specific material or technique that has resulted in superior outcomes or prevented total bone loss. OBJECTIVES: This clinical study aims to evaluate radiographically the effectiveness of using bovine xenograft with platelet-rich fibrin (PRF) membrane on vertical and horizontal alveolar ridge dimensional changes following tooth extraction that are complicated by buccal bone loss. MATERIALS AND METHODS: This study was conducted in Egypt on fourteen patients with a single posterior tooth indicated for extraction. A preoperative cone-beam computed tomography (CBCT) scan confirmed more than 50% loss in buccal bone in each tooth. Extraction sockets were packed with minced PRF clots mixed with a bovine xenograft. Each extraction socket was sealed by PRF membranes. CBCT scans, performed before tooth extraction and after 6 months, were used to assess alveolar ridge changes both vertically and horizontally. RESULTS: There was a significant gain in the buccal and middle of the extraction socket bone height, recording 86.01% (6.33 mm) and 206.45% (9.6 mm), respectively. There was an insignificant bone loss in the lingual bone height and width, recording - 8.49% (-1.06 mm) and - 13.39% (1.05 mm), respectively. The results also showed a non-significant decrease in alveolar bone density (-14.06%) between pre-operative bone present apical to the extraction socket and newly formed bone inside the socket. CONCLUSIONS: Ridge preservation/augmentation techniques using a bone graft mixed with PRF and covered by PRF membranes in fresh extraction sockets complicated by the loss of buccal bone result in buccal bone augmentation and a reduction in horizontal and vertical ridge collapse after tooth extraction. CLINICAL RELEVANCE: The bovine xenograft in conjunction with PRF can be used immediately after extraction for ridge preservation, providing adequate bone width and height for implant placement.