Abstract
Phased energy storage technologies are highly advantageous and feasible for storing and utilizing clean renewable energy resources, for instance, solar energy and waste heat, and it is an effective method to improve energy efficiency and save energy. However, phase change energy storage has some problems, for example, low thermal conductivity and phase change leakage, which lead to limited application. In this paper, anisotropic graphene aerogels were prepared by ice crystal template method with high thermal conductivity of graphene, and silver was attached to the pore wall graphene sheets and the graphene sheet boundaries of the aerogels. The results show that anisotropic graphene aerogels were successfully prepared, and SEM and EDS indicate that up to 9.14 at % silver was successfully attached to the graphene sheets and boundaries. The anisotropic thermal conductivity of the PArGO phase change composites after adsorption of the paraffin is significant, with a maximum axial thermal conductivity of PArGO of 1.20 W/(mK) and radial thermal conductivity of 0.54 W/(mK), compared to the pure paraffin (0.26 W/(mK)) increased by 362% and 108%, respectively. The enthalpy of the composite has been reduced to 149.6 J/g due to the silver particles attached, but the thermal properties have been greatly improved. In experiments simulating real temperature changes, PArGO achieves phase transitions very fast, with a 74% improvement on thermal efficiency of storage and discharge over the pure paraffin.