Abstract
INTRODUCTION: Discerning whether range of motion (ROM) is restricted by morphology or other pain sources is challenging in patients with femoroacetabular impingement syndrome (FAIS). Computed tomography (CT) motion simulation provides a hypothetical ROM based on morphology. This study aimed to explore associations between ROM measured using CT motion simulation and maximum passive ROM measured clinically using three dimensional (3D) motion analysis in patients with FAIS, prior to and post arthroscopic hip surgery. MATERIALS AND METHODS: Eight males with FAIS (in total 12 hip joints) were included in this explorative feasibility study. Participants were examined using CT according to a low-dose protocol prior to and 7-months post arthroscopic surgery. Software was used to simulate at which ROM the impingement would occur. With the hip in 90 degrees' flexion, maximum passive range of internal hip rotation, and maximum passive internal hip rotation coupled with adduction was examined clinically using 3D motion analysis pre- and postoperatively. Spearman rank correlation coefficients and linear regressions examined associations between methods. RESULTS: Preoperatively, the correlation between maximum internal hip rotation measured using CT motion simulation and 3D motion analysis was strong (r = 0.71, p = 0.009). Linear regressions demonstrated that maximal internal rotation measured using CT motion simulation was predominantly larger than when measured using 3D motion analysis. Postoperatively, and when maximum internal rotation was coupled with adduction, no correlations were found between the two methods. CONCLUSIONS: The hypothetical morphology restricted ROM is larger than clinically assessed pain restricted ROM, both prior to and post hip arthroscopy. These findings suggest that ROM is restricted by pain rather than mechanical, morphology-based impingement in individuals with FAIS.