Abstract
INTRODUCTION: Maxillary reconstruction is often a challenging task for the surgeons because of the complex anatomy. However, with the advances in virtual surgical planning (VSP) and 3D printing technology there is a new avenue for the surgeons which offers a suitable alternative to conventional flap-based reconstructions. PATIENTS AND METHODS: In this article, we have described 4 case scenarios which were managed with the help of VSP and additive manufacturing technology for complex maxillary reconstruction procedures. Use of the technologies aided the clinician in achieving optimal outcomes with regards to form, function and esthetics. DISCUSSION: Virtual surgical planning (VSP) has gained a lot of impetus in past 1 decade. These aides the surgeon in determining the extent of disease and also carry out the treatment planning. In addition to VSP, the concept of additive manufacturing provides a viable alternative to the conventional reconstruction modalities for maxillary defect rehabilitation. Increased accuracy, rehabilitation of normal anatomical configuration, appropriate dental rehabilitation, decreased intra-operative time and post-operative complications are some of the advantages. In addition, patient-specific implants eliminate the need for a separate donor site. Apart from the treatment of pathologies, they also can be used for reconstruction of post-traumatic defect, where endosteal implant placement is not possible. CONCLUSION: These modalities show promising results for reconstruction of complex maxillary defects.