Abstract
This article reveals the chip formation and the reducing of cutting force mechanisms of nickel-based superalloy Inconel 718 under elliptical vibration cutting using finite element analysis software. The results are compared with traditional cutting methods. The elliptical motion trajectory of the tool in elliptical vibration cutting machining is analyzed, and a two-dimensional finite element elliptical vibration cutting model is established. The effects of dynamic impact on the elliptical vibration cutting of Inconel 718 were discussed in terms of the surface morphology, chip formation mechanism, and cutting force reduced mechanism. The simulation results show that (1) compared with traditional cutting, the surface morphology of the workpiece machined by elliptical vibration cutting is better, and the machined surface has obvious elliptic indentation; (2) in traditional cutting, sawtooth chips are formed through shear slip, while in elliptical vibration cutting, the faster relative cutting speed vc, higher tool-tip temperature, and smaller material removal cross-sectional area cause a more prominent thermal softening effect in the chip formation process than that in traditional cutting, which leads to the plastic flow to be dominant in the material removal process, resulting in the strip chips; and (3) compared with traditional cutting, the normal cutting force and the tangential cutting force in elliptical vibration cutting are separately reduced about 51.4% and 60.8%.