Abstract
Entropy generation from a mechanical and thermal perspective are quantitatively compared via molecular dynamic (MD) simulations and mechanical and thermal experiments. The entropy generation values regarding mechanical tensile loading-which causes invisible damage-of the Polyamide 6 (PA6) material are discussed in this study. The entropy values measured mechanically and thermally in the MD simulation were similar. To verify this consistency, mechanical and thermal experiments for measuring entropy generation were conducted. The experimentally obtained mechanical entropy was slightly less than that calculated by MD simulation. The thermal capacity is estimated based on the specific heat capacity measured by differential scanning calorimetry (DSC), applying the assumed extrapolation methods. The estimated entropy generation was higher than the aforementioned values. There is a possibility that the entropy-estimating method used in this study was inappropriate, resulting in overestimations. In any case, it is verified that entropy increases with mechanical loading and material invisible damage can be qualitatively detected via thermal property measurements.