Abstract
The article presents the dependence of the morphology as well as micromechanical and sclerometric properties of Al(2)O(3) layers on the parameters of anodizing of aluminum alloys. The oxide layers were produced on the EN AW-5251 aluminum alloy by means of a direct current anodizing in a three-component electrolyte. The input variables (current density and electrolyte temperature) were selected based on the overall design of the experiment. The current density was 1, 2, 3 A/dm(2), and the electrolyte temperature was 283, 293, 303 K. The surface morphology was examined using a scanning electron microscope (SEM), and then the microscopic images were analyzed using a graphics program. The micromechanical and sclerometric properties were examined by determining the H(IT) hardness and three critical loads: Lc1 (critical load at which the first damage of the tested layers occurred-Hertz tensile cracks inside the crack), Lc2 (critical load at which the first cohesive damage of the layers occurred) and Lc3 (load at which the layers were completely damaged). Sclerometric tests with the use of scratch tests were supplemented with pictures from a scanning microscope, showing the scratches. The produced layers are characterized by a hardness above 3 GPa and a porosity of 4.9-10.3%. Such a range of porosity of the produced layers allows their wide application, both for sliding associations with polymers and for their modification.