Abstract
The research is concerned with the use of double walls filled with aluminium foam for an open wagon in order to decrease the dynamic stresses during the operational modes. The research presents the strength calculation for the bearing structure of an open wagon with consideration of the engineering solutions proposed. It was found that the maximum equivalent stresses appeared in the bottom section of the centre sill behind the back support; they amounted to about 315 MPa and did not exceed the allowable values. The maximum displacements were detected in the middle section of the centre sill and amounted to 9.6 mm. The maximum deformations were 1.17 × 10(-2). The research also presents the strength calculation for a weld joint in the maximum loaded zones of the bearing structure of an open wagon and gives the results of a modal analysis of the bearing structure of the improved open wagon. It was found that the critical oscillation frequencies did not exceed the allowable values. The results of the research may be useful for those who are concerned about designing innovative rolling stock units and improving the operational efficiency of railway transport.