Abstract
Ferric perchlorate was tested for the first time as a new catalyst to accelerate the esterification of microcrystalline cellulose (MCC) at room temperature in a less amount of acetic anhydride compared to the amount used in the conventional methods. It was possible to manufacture cellulose acetate (CA) with a high yield of up to 94%. The influence of changes in reaction time, catalyst amounts, and acetic anhydride on the characterization of cellulose acetate produced was investigated. The optimum condition for esterification of 2.0 g (12.34 mmol) MCC was found to be: 10 mL (105.98 mmol) AC(2)O, 200 mg (0.564 mmol, anhydrous basis) of Fe(ClO(4))(3)·xH(2)O and 1 h reaction time at room temperature. The substitution degree of CA was investigated by FTIR and (1)H-NMR spectroscopy. Thermal stability of CA was studied using TGA, DTA and DSC analyses. The degree of polymerization and the polydispersity index (PDI) were obtained using Gel permeation chromatography (GPC). This study verified the direct and efficient synthesis of di- and tri-cellulose acetate in one-pot reaction using Fe(ClO(4))(3)·xH(2)O as a catalyst without using solvent.