Abstract
Waste paper is often underutilized as a low-value recyclable resource and can be a potential source of cellulose nanofibers (CNFs) due to its rich cellulose content. Three different processes, low acid treatment, alkali treatment and bleaching treatment, were used to pretreat the waste paper in order to investigate the effect of different pretreatments on the prepared CNFs, and CNFs obtained from bleached pulp boards were used as control. All sample fibers were successfully prepared into CNFs by 2,2,6,6-tetramethyl-piperidine-1-oxyl (TEMPO) oxidation. It was quite obvious that the bleached CNFs samples showed dense fibrous structures on a scanning electron microscopy (SEM), while needle-like fibers with width less than 20 nm were observed on a transmission electron microscopy (TEM). Meanwhile, the bleaching treatment resulted in a 13.5% increase in crystallinity and a higher TEMPO yield (e.g., BCNF, 60.88%), but a decrease in thermal stability. All pretreated CNFs samples showed narrow particle size distribution, good dispersion stability (zeta potential less than -29.58 mV), good light transmission (higher than 86.5%) and low haze parameters (lower than 3.92%). This provides a good process option and pathway for scalable production of CNFs from waste papers.