Abstract
BACKGROUND: The aim of this study was to investigate the shear bond strength of CAD/CAM and conventional heat polymerized acrylic resin denture bases bonded to self-cured and heat-cured acrylic resins after aging. MATERIAL AND METHODS: A total of 40 cubic specimens were fabricated from conventional heat-polymerized and CAD/CAM denture base resins. Denture base resin specimens in each group were divided into two subgroups (n=10) in which they were bonded to either a heat-cured (HC) or a self-cured (SC) reline resin. Subsequently, the specimens were subjected to thermocycling. Then the shear bond strength (SBS) of specimens was measured using the universal testing machine. After testing, modes of failure were examined using light microscopy. The results were submitted to statistical analysis. RESULTS: Mann-Whitney test showed that in each group of denture base materials, specimens bonded to HC reline resin had significantly higher SBS than those bonded to SC reline resin (P<0.001). Conventional denture base bonded to HC resin exhibited the highest value of SBS. There was no statistically significant differences between the SBS of HC reline resin bonded to conventional and CAD/CAM with regards to SBS (P=0.218). However, the SBS of SC reline resin was significantly higher when bonded to CAD/CAM compared to conventional denture base resin (P<0.001). CONCLUSIONS: Heat-cured reline resin showed higher shear bond strength to both CAD/CAM and conventional heat-polymerized denture resin in comparison to self-cured reline resin. Although there was no difference between the bond strength of heat-cured reline resin to CAD/CAM and conventional denture base, self-cured reline material produced stronger bond with CAD/CAM denture base. Key words:CAD/CAM, shear bond strength, reline, denture base resin.