Abstract
BACKGROUND: Class II malocclusions represent anteroposterior dysplasia usually resulting from mandibular retrusion. Along with a retropositioned mandible, it can be associated with either upward or backward jaw rotation. High angle cases are often associated with a short ramal height, steeper mandibular plane, and large gonial angle. Twin block is a commonly used myofunctional appliance that incorporates bite planes that direct the occlusal forces in a more favorable direction for correction of the retrognathic mandible. We aimed to evaluate skeletal, dental, and soft tissue changes following modified twin block appliance therapy in high-angle cases. METHODS: A cephalometric study was performed on 15 growing (10-14 years) high angle (Frankfort mandibular angle 28-35°) Class II Division I malocclusion patients undergoing twin block therapy. Skeletal, dental, and soft tissue changes were evaluated by cephalometric analysis using Dolphin software. RESULTS: Pre- and post-treatment changes in cephalograms were assessed by analysis of variance and paired t-test. Significant changes in the position of the mandible (angle between Sella-Nasion-Point B [SNB] increased by 3.9 degrees, P=0.02), Wits appraisal (decreased by 1.54 mm, P=0.04), maxillo-mandibular relationship (angle between Point A-Nasion-Point B [ANB] decreased by 3.74 degrees, P=0.02) were observed. Soft tissue changes like the nasolabial angle were also significant, increasing by 3.8 degrees (P=0.04) and lower lip relation to E-line (reduction in lower lip protrusion) by 2 mm (P=0.04). Vertical parameters showed non-significant changes, like the Frankfort mandibular angle (FMA) increased by 0.07 degrees, (P=0.67), the angle between Sella-Nasion and Gonion-Gnathion (SN-Go-Gn) increased by 0.33 degrees, (P=0.67), Y-axis increased by 0.2 degrees, (P=0.32). The upper incisor inclination decreased non-significantly from 115.27±1.33 to 113.42±1.65 degrees, (P=0.12) and lower incisor increased non-significantly from 100.13±2.23 to 101.80 ±1.37 degrees, (P=0.08). CONCLUSIONS: Modified twin block appliance can be used to successfully treat Class II Division I high angle cases with good vertical control.