Abstract
The aim of the present paper is that of conducting a study on the basis of which the optimal parameters for the manufacturing of polymer parts by means of the single point incremental forming process can be chosen in such a way that the process forces have minimum values. Two polymeric materials with a 3 mm thickness, polyamide and polyethylene, were chosen for the analysis. The other input parameters that were considered were: the punch diameter, the step on vertical direction and the wall angle. The Taguchi method was chosen for the design of experiments. Each of the input parameters, except for the material, were varied on three levels-for the punch diameter: 6 mm, 8 mm and 10 mm; for the step on vertical direction: 0.5 mm, 0.75 mm and 1 mm; and for the wall angle: 50°, 55° and 60°. Forces were measured in the three directions of the coordinate axes and the results were analyzed based on the signal-to-noise ratio and an analysis of variance with the aim of minimizing the values of the forces. Considering the input parameters analyzed, it was concluded that the forces are most influenced by the material, followed by the punch diameter, the step on vertical direction and the wall angle.