Abstract
Sludge palm oil (SPO) with high free fatty acid (FFA) content was processed using a continuous and double-step esterification production process in a rotor-stator-type hydrodynamic cavitation reactor. Three-dimensional printed rotor was made of plastic filament and acted as a major element in minimizing the FFA content in SPO. To evaluate the reduced level of FFAs using both methods, five independent factors were varied: methanol content, sulphuric acid content (H2SO4), hole diameter, hole depth, and rotor speed. The first-step conditions for the esterification process included 60.8 vol% methanol content, 7.2 vol% H2SO4 content, 5.0 mm diameter of the hole, 6.1 mm depth of the hole, and 3000 rpm speed of the rotor. The initial free fatty acid content decreased from 89.16 wt% to 35.00 wt% by the predictive model, while 36.69 wt% FFA level and 94.4 vol% washed first-esterified oil yield were obtained from an actual experiment. In the second-step, 1.0 wt% FFA was achieved under the following conditions: 44.5 vol% methanol content, 3.0 vol% H2SO4 content, 4.6 mm hole diameter, 5.8 mm hole depth, and 3000 rpm rotor speed. The actual experiment produced 0.94 wt% FFA content and 93.9 vol% washed second-esterified oil yield. The entire process required an average electricity of 0.137 kWh/L to reduce the FFA level in the SPO below 1 wt%.