Abstract
INTRODUCTION: This study aimed to develop a methodology for establishing the power-duration relationship in cross-country skiers and to investigate the influence of incline on critical power ( CP ) model parameters. METHODS: Twelve trained male cross-country skiers performed four constant work-rate predictive trials on a motor-driven treadmill, using the double poling sub-technique, to determine their power-duration relationships at 2° and 8° inclines in a randomized order. The testing protocol also included maximum speed tests performed at both inclines. Power-duration relationships were modeled using a modified expression of the three-parameter critical power model. RESULTS: The derived power-duration relationships were significantly different between the two inclines. At an 8° incline, the estimated work capacity above CP (i.e., W' ) was more than two times higher than at a 2° incline ( 24.87 ± 8.75 kJ vs. 7.07 ± 1.61 kJ, respectively; Z = 3.06 , P = 0.002 , rrb = 0.88 ), which was partly explained by an increased anaerobic power capacity (i.e., Pan = 4.82 ± 0.64 W ⋅ kg(-1) vs. 1.67 ± 0.34 W ⋅ kg(-1), respectively; Z = 3.06 , P = 0.002 , rrb = 0.88 ). Although CP estimates differed by approximately 16% between the two inclines on a group level ( 2.78 ± 0.22 W ⋅ kg(-1) vs. 2.39 ± 0.74 W ⋅ kg(-1) at a 2° and at an 8° incline, respectively), a moderate non-significant effect of incline was observed with large individual variances ( Z = 1.88 , P = 0.06 , rrb = 0.54 ). The incline had a non-significant effect on the time constant parameter estimates ( Z = 1.57 , P = 0.12 , rrb = 0.45 ), yet inter-individual variation remained considerable. DISCUSSION: The findings demonstrate that in cross-country skiing, both W' and Pan are highly incline-dependent, showing markedly higher values at steeper gradients. Moreover, the variability observed in CP and W' across inclines exceeded the typical sensitivity of these parameters to external factors reported in cycling. A large proportion of the incline-related changes in model parameters could be explained by accounting for the estimated variations in gross efficiency across speeds and inclines. However, the persistence of a significant difference in W' even when expressed in terms of estimated metabolic power at steeper inclines suggests the involvement of additional physiological mechanisms, potentially a larger amount of recruited muscle mass due to differences in muscle fiber recruitment between conditions.