Abstract
In this work, the Mg-8Li-3Al-0.3Si (LAS830) alloy was prepared by the vacuum melting method. The as-cast alloy was subjected to backward extrusion at 250 °C and then spun at 250 °C. The microstructure and mechanical properties of the alloy during deformation were studied. The results showed that the LAS830 alloy primarily consisted of α-Mg and β-Li phases, and the AlLi, MgLi(2)Al, and Mg(2)Si phases were dispersed. After backward extrusion, the grains and AlLi phase were refined, the β-Li phase recrystallized, and the fine MgLi(2)Al phase precipitated. The spinning of the extruded alloy tubes resulted in the lamellar distribution of an α/β duplex microstructure, with even finer grains and more dispersed precipitates. The combined deformation significantly enhanced the alloy's strength and ductility, with the ultimate tensile strength reaching 235.4 MPa and an elongation of 15.74%. In addition, the average hardness of the α/β phase increases after backward extrusion, but the average hardness of the β-Li phase increases further after spinning. The as-cast LAS830 alloy exhibited a high work hardening rate but a low softening rate. With reverse extrusion, the work hardening rate decreased and the softening degree increased. Compared with backward extrusion, the work hardening rate and softening degree of the LAS830 alloy was reduced after spinning due to the combined effect of the lamellar distributed duplex microstructure and the dispersed second phases in the alloy, while its softening rate increased.