Abstract
Introduction: Advancements in thermo-mechanical surface treatment of endodontic nickel-titanium (NiTi) instruments introduced another aspect of variation. Particularly related to their metallurgy, which influences their behaviour in relation to temperature. This is clinically significant, considering the variation in the temperatures inside the root canal during instrumentation. This study aimed to compare the effects of different temperatures on the bending stiffness, cyclic fatigue resistance, and cutting efficiency of two reciprocating heat-treated NiTi files: R-Motion (RM) and WaveOne Gold (WOG). Methodology: Bending stiffness was examined in a temperature-controlled water bath, measuring the maximum force in Newtons during a 3 mm tip horizontal displacement. The cyclic fatigue resistance was tested in a simulated stainless-steel canal (35° curvature, 6 mm radius) in dynamic mode at 22 °C, 37 °C, and 45 °C. Time to fracture (TTF) and length of fractured fragment were recorded, and representative samples were examined using scanning electron microscopy. The cutting efficiency was assessed using bovine bone slabs measuring 1.5 mm in thickness and 15 mm in width. The files were activated in reciprocation mode for three minutes while resting on the upper surface of the slab, while submerged in a water bath maintained at 22 °C, 37 °C, or 45 °C. The maximum cutting depth was measured in millimetres under magnification. Additionally, Differential Scanning Calorimetry (DSC) analysis was performed for three specimens of each file type. Results: RM exhibited significantly higher TTF, longer fractured fragments, and smaller cutting depths than WOG across all temperatures. The RM was significantly stiffer at 37 °C and 45 °C only. For each file type, increasing the temperature was associated with a significant increase in stiffness (p < 0.01), except for WOG between 22 °C and 37 °C (p = 0.199). The TTF was significantly higher in RM at 22 °C, while the TTF in WOG increased significantly with lower temperatures. No effect was observed on the length of the fractured fragment. Lower temperatures were also associated with reduced cutting efficiency in both files. Conclusions: Temperature has a significant impact on the properties and performance of RM and WOG and should be considered during instrumentation. File design has a greater influence on their strength and cutting ability than their transformation behaviour related to heat treatment.