Abstract
OBJECTIVE: To compare the flexural properties of rectangular nickel-titanium (Ni-Ti) orthodontic wires in occlusoapical and faciolingual orientations using a standardized test method. MATERIALS AND METHODS: Twenty-two rectangular Ni-Ti wire groups were tested in occlusoapical (ribbon) orientation: eight conventional Ni-Ti products, five superelastic Ni-Ti products, and nine thermal Ni-Ti products (n = 10 per group). Six products of thermal Ni-Ti wire were tested in faciolingual (edgewise) orientation. A three-point bending test was performed to measure deactivation force at 3.0-, 2.0-, 1.0-, and 0.5-mm deflections of each rectangular wire at 37.0 ± 0.5°C. Analysis of variance and post hoc Student-Newman-Keuls tests were used to compare the mean values of the different groups (α = .05). RESULTS: The ranges of deactivation forces varied greatly with different kinds, sizes, products, and deflections of Ni-Ti wires. One product of conventional and superelastic Ni-Ti wires had steeper force-deflection curves. Four products had similarly shaped flat force-deflection curves, whereas the sixth product had a moderately steep force-deflection curve. Thermal Ni-Ti wires had smaller deactivation forces ranging from 0.773 N (78.8 g) to 2.475 N (252.4 g) between deflections of 1.0 and 0.5 mm, whereas wider ranges of force from 3.371 N (343.7 g) to 9.343 N (952.7 g) were predominantly found among conventional Ni-Ti wires between deflections of 3.0 and 2.0 mm. CONCLUSIONS: Clinicians should critically select archwires for use in the occlusoapical orientation not only based on Ni-Ti wire type, size (0.022 × 0.016-in or 0.025 × 0.017-in), and product but also with deactivation deflections from 0.5 and 1.0 mm to obtain light forces in the occlusoapical orientation.