Abstract
Superalloy parts place high demands on machined surface integrity and serviceability. In the machining process of superalloys, the cutting fluid is usually used to improve the machining performance. Cutting fluids with cooling and lubrication functions have a relatively large effect on the surface microstructure and residual stress as well. The corrosion damage caused by cutting fluid to the machined surface, during machining and residual, are also worth considering. In this paper, the machining performance of typical binary Ni Cr solid solution, age-hardened, nickel-based superalloy NiCr20TiAl T6, under two commonly used cutting fluids, Blasocut and E709, was analyzed, including cutting performance, surface quality, machining surface corrosion characteristics, and so on. The results showed that the surface residual stress could be improved by adding both cutting fluids compared with the deionized water. Blasocut had better lubrication properties, which could reduce friction and heat production. Pitting holes were found on the polished surface after 45 days with E709 cutting fluid, which was more corrosive than Blasocut. According to this research, a reasonable cutting fluid can be selected to reduce the surface corrosion and improve the service life and performance of parts.