Abstract
In this work, acrylonitrile butadiene styrene (ABS) copolymer from electronic waste (e-waste) was used to produce filaments for application in 3D printing. Recycled ABS (rABS) from e-waste was blended with virgin ABS (vABS) in different concentrations. By differential scanning calorimetry, it was observed that the values of the glass transition temperatures for vABS/rABS blends ranged between the values of vABS and rABS. Torque rheometry analysis showed that the processability of vABS was not compromised with the addition of rABS. Rheological measurements showed that the viscosity of vABS was higher than that of rABS at low frequencies and indicated that vABS and rABS are immiscible. Impact strength (IS) tests of the 3D printed samples showed an increase in the IS with an increase in the rABS content up to 50 wt%. Blending vABS with rABS from e-waste is promising and proved to be feasible, making it possible to recycle a considerable amount of plastics from e-waste and, thus, contributing to the preservation of the environment.