Abstract
The present paper investigates the possibility of replacing the traditional L-type corner joint used in chair construction with a 3D printed connector, manufactured using the Fused Filament Fabrication (FFF) method and black PLA as filament. The connector was designed to assemble the legs with seat rails and stretchers, and it was tested under diagonal tensile and compression loads. Its performance was compared to that of the traditional mortise-and-tenon joint. Stresses and displacements of the jointed members with connector were analyzed using non-linear Finite Element Method (FEM) analysis. Both connector and mortise-and-tenon joint were employed to build chair prototypes made from beech wood (Fagus sylvatica L.). Digital Image Correlation (DIC) method was used to analyze the displacements in the vicinity of the jointed members of the chairs. Seat and backrest static load tests were carried out in order to verify if the chairs withstand standard loading requirements. Results indicated that the 3D printed connector exhibited equivalent mechanical performance as the traditional joint. The recorded displacement values of the chair with 3D-printed connectors were higher than those of the traditional chair reaching 0.6 mm on the X-axis and 1.1 mm on the Y-axis, without any failures under a maximum vertical load of approximately 15 kN applied to the seat. However, it successfully withstood the loads for seating and backrest standard tests, in accordance with EN 1728:2012, without any structural failure. This paper presents a new approach for the chair manufacturing sector, with potential applicability to other types of furniture.