Abstract
The crystallographic, optical, and electrical properties of manganese sulfide thin films depend on the control of the temperature precursors in the synthesis process, as shown by the results of this work. MnS thin films were deposited on glass substrates using the SILAR method and over an additional layer of CdS synthesized by chemical bath deposition (CBD) to acquire a p-n heterojunction. SILAR is an inexpensive method performed with a homemade robot in this case. Temperature in the solution precursors varied from 20 to 80 °C in four experiments. The morphology and structure of MnS and FTO/CdS/MnS thin films were studied through scanning electron microscopy (SEM) and grazing-incidence X-ray diffraction (GIXRD); the results indicate that materials showed a polycrystalline behavior, a diffraction peak of α- MnS cubic phase was observed with lattice constants values, ranging from 4.74 to 4.75 Å. Additionally, Raman spectroscopy showed a signal corresponding to the transversal optical phonons of MnS at a wavenumber near 300 cm(-1). UV-vis spectroscopy showed optical bandgap values of 3.94, 4.0, 4.09, and 4.26 eV for thin films obtained at 20°, 40°, 60°, and 80 °C. respectively. Results indicated 80 °C as an optimal cationic precursor process temperature, achieving optical transmittance T% and good film quality according to SEM and GIXRD for the synthetization of MnS. The current-voltage (I-V) characterization in the heterojunction showed a characteristic diode curve with an open circuit voltage (VOC) of 300 mV under illumination, which indicated that the manganese sulfide behaves as p-type material contributing with positive charge carriers, while CdS behaves as n-type material.