Abstract
Understanding the mechanics of fiber attrition during the extrusion process is highly important in predicting the strength of long fiber-reinforced thermoplastic composites. However, little work has been done to investigate the mechanics of fiber dispersion and its effects on fiber attrition. This study aims at investigating fiber dispersion in simple shear flows for long fiber-reinforced thermoplastic pellets. Depending on the fabrication process, fiber bundles display distinct levels of compaction within the pellets. Studies have shown that morphological differences can lead to differences in dispersion mechanics; therefore, using a Couette rheometer and a sliding plate rheometer, coated and pultruded pellets were subjected to simple shear deformation, and the amount of dispersion was quantified. Additionally, a new image-based analysis method is presented in this study to measure fiber dispersion for a multi-pellet-filled system. Results from the single-pellet dispersion study showed a small amount of correlation between the dimensionless morphological parameter and the dispersion measurement. Pultruded and coated pellets were both found to have similar dispersion rates in a multi-pellet system. However, pultruded pellets were found to have a higher dispersion value at all levels when compared with coated pellets in both dispersion studies.