Abstract
Heavy metals in water are a serious environmental problem due to their accumulation and toxicity; there are several processes we can use to address this issue, but adsorption is the most popular due to its simplicity and efficiency. Polysaccharides such as cellulose have received attention as adsorbents for heavy metals, and cotton-chitosan composites (CCs) were developed here with nontoxic reagents such as carboxylic acids as crosslinkers and NaH2PO4 as a catalyst to achieve chitosan covalent crosslinkage into oxidized cotton textiles with H2O2. The composites were characterized by fourier-transform infrared spectroscopy (FTIR), elemental analysis (EA), X-ray photoelectron spectroscopy (XPS), atomic-force and scanning electron microscopy (AFM and SEM), and tensile strength; the adsorption of lead ions (Pb) was evaluated with cotton-chitosan composites and quantified by microwave plasma atomic emission spectroscopy (MP-AES). The composites showed a maximum incorporation of chitosan of 27.62 mg per gram of cotton textile. A tensile strength analysis of the composite showed a Young's modulus approximately 1 MPa higher than that of cotton textile. The adsorption of lead ions with composites in an aqueous solution at pH 5 and 25 °C was circa 74% after 6 h of contact, as determined by MP-AES. This work is an approach to demonstrate the potential of these polysaccharides, modified by "green" procedures to remove pollutants from water.