Abstract
INTRODUCTION: The desired outcome of the implantation of active middle ear implants is maximum coupling efficiency and a minimum of conductive loss. It has not been investigated yet, which loading forces are applied during the process of coupling, which forces lead to an optimum actuator performance and which forces occur when manufacturer guidelines for coupling are followed. METHODS: Actuator output was measured by laser Doppler vibrometry of stapes motion while the actuator was advanced in 20 μm steps against the incus body while monitoring static contact force. The occurrence of conductive losses was investigated by measuring changes in stapes motion in response to acoustic stimulation for each step of actuator displacement. Additionally, the electrical impedance of the actuator was measured over the whole frequency range at each actuator position. RESULTS: Highest coupling efficiency was achieved at forces above 10 mN. Below 1 mN no efficient coupling could be achieved. At 30 mN loading force, which is typical when coupling according to manufacturer guidelines, conductive losses of more than 5 dB were observed in one out of nine TBs. The electrical impedance of the actuator showed a prominent resonance peak which vanished after coupling. CONCLUSION: A minimum coupling force of 10 mN is required for efficient coupling of the actuator to the incus. In most cases, coupling forces up to 100 mN will not result in clinically relevant conductive losses. The electrical impedance is a simple and reliable metric to indicate contact.