Abstract
In order to shorten the ignition delay of 2-azido-N,N-dimethylethanamine (DMAZ) and dinitrogen tetroxide (NTO), four amines [tert-butylamine, pyrrole, N,N,N',N'-tetramethyl ethylenediamine (TMEDA), and diethylenetriamine (DABH)] with a mass fraction of 5% were added to DMAZ, and the potential energy change and the product change during the reaction of the mixture of an additive and DMAZ with NTO were analyzed by Reactive molecular dynamics (ReaxFF MD) calculation. Then, the ignition delay of the mixture of the additive and DMAZ as well as pure DMAZ with NTO was measured by a drop experiment with a photoelectric sensor and high-speed camera. The results show that the addition of pyrrole greatly reduced the time to reach the maximum system energy and greatly increased the rate of HNO(2) formation. The dripping of the fuel was approximately a uniform linear motion, and the expression was y = 43.13 + 7.16x. The ignition delay time recorded by the camera was in good agreement with that of the optical signal. The measured ignition delay time for DMAZ with NTO was 261.5 ms. The mixture of pyrrole and DMAZ with NTO had the shortest ignition delay time of 100 ms, and the proportion of shortening the ignition delay time was the largest. The results of the droplet experiment were consistent with those of ReaxFF MD simulation, indicating that HNO(2) plays an important role in the ignition delay, that is, the formation rate of HNO(2) is positively correlated with the ignition delay.