Abstract
High internal phase Pickering emulsions (HIPPE) have received significant research attention in the last two decades due to their potential for a wide range of applications. The appropriate processing of such high-viscosity emulsions, hundreds of times more viscous than that of the continuous phase, and the control of the final droplet size remain challenges to be tackled. Our research targeted this knowledge gap by examining the influence of the emulsion formulation and the processing conditions on the final droplet size. The dispersed phase fraction (100 cSt silicon oil) ranged between 75 and 80%. The emulsions were produced in a regular mixing tank equipped with a helical ribbon impeller rotating at a low speed (100-150 rpm). The effective viscosity of the continuous phase was obtained from the experimental torque measurements. The droplet size distributions were measured after emulsification and dilution in the continuous phases. It is shown that the capillary number obtained from the observed emulsification performance can help predict the final droplet size. Our approach provides a straightforward methodology to generate concentrated Pickering emulsions with controlled and predictable droplet size.